Webseiten-Werkzeuge


meshcore:lora_hardware:elecrow_thinknode_m2

Dies ist eine alte Version des Dokuments!


Elecrow ThinkNode M2

„Wer ein Bild hat, bitte einstellen. HINWEIS: Bitte nur selbst erstelle Bilder einstellen! (Urheberrecht)“

Dieses Device kann zusammen mit der MeshCore Firmware als Companion Radio, als Repeater oder auch als Roomserver verwendet werden.

Zusammenfassung

-

Spezifikationen

  • Main Processor(ESP32-S3 Module:
    • CPU/SoC: Equipped with high-performance Xtensa 32-bit LX7 dual-core processor, with a main frequency of up to 240MHz
    • System Memory: 512KB SRAM, 8M PSRAM
    • Storage: 4M Flash,384KB ROM
    • Firmware: Meshtastic firmware is fully compatible, and the signal is transmitted in LoRa mode
  • Display:
    • Size: 1.3 inch
    • Display Materials: OLED
    • Resolution: 128*64
    • Driver Chip: SSH1106
  • Wireless Communication
    • WiFi: Support 802.11a/b/g/n, 2.4GHz
    • Bluetooth: Bluetooth Low Energy and Bluetooth 5.0
    • LoRa: SX1262 LoRa module, US 915MHz / EU 868MHz
  • Hardware
    • Interface: Type-C Interface, IPEX antenna connector (internal), battery connector (internal)
    • Function: LCD display, USB2.0, PMU power management, USB to UART, buzzer, buck circuit, etc.
    • Button: Power button, Function button, Reset button, BOOT button
    • LED Indicator: Power indicator, charging indicator
  • Other
    • Power Input: 5V/1A, supports USB or lithium battery power supply
    • Power consumption: The maximum working power consumption is about 217mA, and the low power consumption is about 136mA (screen-off state)
    • Operating Temperature: -10~50°C
    • Storage Temperature: -20~60 °C
    • Relative humidity: 10%-95%, @ 40°C (non-condensing)
    • Size:
      • With Case:88.4*46*23mm;
      • Without Case:51.5*37*9.5mm
    • Shell: ABS Plastic
    • Net weight: 30g(Without case);50g(With case)
meshcore/lora_hardware/elecrow_thinknode_m2.1795072582.txt.gz · Zuletzt geändert: von mellinux